Welcome to the fifth installment of common misconceptions about spring products. Many designers of coil springs just put placeholders in springs data. Read on as we discuss!

Index Design Theory and Definition

There is a direct correlation between wire size and the ID/OD (index) that affects the ability to coil on modern-day equipment. The index of spring is the relationship between the mean coil diameter (MD) and the wire size(WS).  The mean wire diameter is the center of the coil body which is:

(MD = OD – WD) or (MD = ID  + WD)

The index is the Mean coil diameter (MD) divided by the wire diameter.

For Example:

(Index = MD / WD)

(0.500” (MD) / 0.040” (WD) = Index of  12.5)

Now that we’ve discussed this, let’s get into the good, the bad, and the ugly:

• Spring Index: 0 – 3.9: almost impossible to manufacture (ugly)
• Spring Index = 4 – 5: Difficult but not impossible (bad)
• Spring Index = 6-12: Best Range (good)
• Spring Index = 13 – 15: Above Best by not Difficult (a little bad)
• Spring Index = 15 – 25: Difficult (bad)
• Spring Index = > 25: difficult to manufacture (ugly) tolerances are larger

What does this mean in layman’s terms? The index has a direct impact on the ability to hold tolerances on key dimensions in the spring product.

• (ID, OD) on all coil springs (compression, torsion, and extension)
• Free Length on compression springs and extension springs
• Torsion Spring Leg relationships
• Hook relationships on extension springs

This means higher cost, and possibly a situation where the spring can’t be manufactured.  Also with difficult and ugly springs, the cost is driven up just by the spring rate, and the ability to hold tolerances. Let Apex Spring and Stamping design and make those calculations work for you.  We are experts in spring designs and we can lead you to a better and more cost-effective solution.

How can we help?

How can we help? Call us today or contact us below!

[/fc-

Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn